Kornienko Elena E. et al. 2017 no. 3(76)

ОБРАБОТКА МЕТАЛЛОВ № 3 (76) 2017 50 МАТЕРИАЛОВЕДЕНИЕ poluchenie i primenenie tugoplavkikh soedinenii [Properties, production and using of refractory compounds]. Ed. by T.Ya. Kosolapova. Мoscow, Metallurgiya Publ., 1986. 928 p. 3. Zhu H., Niu Y., Lin C., Huang L., Ji H., Zheng X. Fabrication and tribological evaluation of vacuum plasma- sprayed B 4 C. Coating Journal of Thermal Spray Technology , 2012, vol. 21, iss. 6, pp. 1216–1223. doi: 10.1007/ s11666-012-9815-5. 4. Schwetz K.A., Sigl L.S., Greim J., Knoch H. Wear of boron carbide ceramics by abrasive waterjets. Wear , 1995, vol. 181–183, pp. 148–155. doi: 10.1016/j.wear.2005.01.020. 5. Sarikaya O., Anik S., Aslanlar S., Okumus S.C., Celik E. Al-Si/B 4 C composite coatings on Al-Si substrate by plasma spray technique. Materials and Design , 2007, vol. 28, iss. 9, pp. 2443–2449. doi: 10.1016/j.matdes.2006.09.007. 6. Feng C., Guipont V., Jeandin M., Amsellem O., Pauchet F., Saenger R., Bucher S., Iacob C. B 4 C/Ni Composite coatings prepared by cold spray of blended or CVD-coated powders. Journal of Thermal Spray Technology , 2012, vol. 21, iss. 3–4, pp. 561–570. doi: 10.1007/s11666-012-9774-x. 7. Cao Y., Huang C., Liu W., Zhang W., Du L. Effects of boron carbide content on the microstructure and properties of atmospheric plasma-sprayed NiCoCrAlY/Al 2 O 3 -B 4 C composite coatings. Journal of Thermal Spray Technology, 2014, vol. 23, iss. 4, pp. 716–724. doi: 10.1007/s11666-014-0061-x. 8. Zeng Y., Lee S.W., Ding C. Study on plasma sprayed boron carbide coating. Journal of Thermal Spray Technology , 2002, vol. 11, iss. 1, pp. 129–133. doi: 10.1361/105996302770349069. 9. Zeng Y., Feng J., Ding C. Microstructure and properties of plasma spraing boron carbide coating. Journal of Materials Science and Technology , 2000, vol. 16, iss. 1, pp. 63–66. 10. Moradi M., Moazeni M., Salimijazi H.R. Microstructural characterization and failure mechanism of vacuum plasma sprayed Ti-6Al-4V/B 4 C composite. Vacuum , 2014, vol. 107, pp. 34–40. doi: 10.1016/j.vacuum.2014.03.028. 11. Salimijazi H.R., Coyle T.W., Mostaghimi J., Leblanc L. Microstructure of vacuum plasma-sprayed boron carbide. Journal of Thermal Spray Technology , 2005, vol. 14, iss. 3, pp. 362–368. doi: 10.1361/105996305X59431. 12. Zhu H., Niu Y., Lin C., Huang L., Ji H., Zheng X. Microstructures and tribological properties of vacuum plasma sprayed B 4 C-Ni composite coatings. Ceramics International , 2013, vol. 39, iss. 1, pp. 101–110. doi: 10.1016/j. ceramint. 2012.05.101. 13. Rafiei M., Salehi M., Shamanian M., Motallebzadeh A. Preparation and oxidation behavior of B 4 C-Ni and B 4 C-TiB 2 -TiC-Ni composite coatings produced by an HVOF process. Ceramics International , 2014, vol. 40, iss. 8, pt. B, pp. 13599–13609. doi: 10.1016/j.ceramint.2014.05.081. 14. Mao Z., Ma J., Wang J., Sun B. Comparison of the coatings deposited using Ti and B 4 C powder by reactive plasma spraying in air and low pressure. Journal of Materials Science , 2009, vol. 44, iss. 12, pp. 3265–3272. doi: 10.1007/s10853-009-3438-3. 15. Lin C., Kong M., Zhu H. Tribological behavior of vacuum plasma sprayed B 4 C-Mo composite coating. Journal of Inorganic Materials , 2016, vol. 31, iss. 1, pp. 100–106. doi: 10.15541/jim20150384. 16. Rafiei M., Salehi M., Shamanian M. Formation mechanism of B 4 C-TiB 2 -TiC ceramic composite produced by mechanical alloying of Ti–B 4 C powders. Advanced Powder Technology, 2014, vol. 25, iss. 6, pp. 1754–1760. doi: 10.1016/j.apt.2014.07.003. 17. Ebrahimian-Hoaaeinabadi M., Azari-Dorcheh K., Moomir-Vaghefi S.M. Wear behavior of electroless Ni-P- B 4 C composite coatings. Wear , 2006, vol. 260, iss. 1–2, pp. 123–127. doi: 10.1016/j.wear.2005.01.020. 18. Kornienko Е.E., Nikulina А.A., Bannov A.G., Kuz’min V.I., Mildebrath M., Bezrukova V.A., Zhoidik A.A. Vliyanie temperatury oplavleniya na strukturu i svoistva samoflyusuyushchikhsya pokrytii na osnove nikelya [The influence of flowing temperature on the structure and properties of the self-fluxing coatings]. Obrabotka metallov (tekhnologiya, oborudovanie, instrumenty) = Metal Working and Material Science , 2016, no. 4 (73), pp. 52–62. doi: 10.17212/1994-6309-2016-4-52-62. 19. Kornienko Е., Shevtsova L., Belousova N., Nikulina А., Smirnov А., Kuz’min V., Rubtsova О. Struktura i svoistva materialov iz alyuminidov nikelya, poluchennykh s ispol’zovaniem razlichnykh tekhnologii [Structure and properties of the nickel aluminide materials obtained using different technologies]. Perspektivnye materialy = Journal of Advanced Materials , 2017, no. 3, pp. 49–58. 20. Kornienko Е.E., Mul’ D.O., Rubtsova О.A., Vaschenko S.P., Kuzmin V.I., Gulyaev I.P., Sergachev D.V. Effect of plasma spraying regimes on structure and properties of Ni 3 Al coatings. Thermophysics and Aeromechanics , 2016, vol. 23, iss. 6, pp. 919–927. doi: 10.1134/S0869864316060147. Conflicts of Interest The author declare no conflict of interest. © 2017 The Authors. Published by Novosibirsk State Technical University. This is an open access article under the CC BY license (http://creativecommons.org/licenses/by/4.0/ ).