OBRABOTKAMETALLOV technology Vol. 27 No. 1 2025 17. Golabczak A., Konstantynowicz A., Golabczak M. Mathematical modelling of the physical phenomena in the interelectrode gap of the EDM process by means of cellular automata and field distribution equations. Experimental and Numerical Investigation of Advanced Materials and Structures, 2013, vol. 41, pp. 169–184. DOI: 10.1007/9783-319-00506-5_11. 18. Kumar A., Mandal A., Dixit A.R., Mandal D.K. Quantitative analysis of bubble size and electrodes gap at different dielectric conditions in powder mixed EDM process. The International Journal of Advanced Manufacturing Technology, 2020, vol. 4 (1), pp. 1–11. DOI: 10.1007/s00170-020-05189-x. 19. Puri A.B., Bhattacharyya B. Modeling and analysis of white layer depth in a wire-cut EDM process through response surface methodology. The International Journal of Advanced Manufacturing Technology, 2005, vol. 25 (3), pp. 301–307. DOI: 10.1007/s00170-003-2045-8. 20. Ablyaz T.R., Zhurin A. Influence of wire-cut electrical discharge machining on surface quality. Russian Engineering Research, 2016, vol. 36 (2), pp. 156–158. DOI: 10.3103/S1068798X16020039. 21. Brown M., Wright D., Saoubi R.M., Gourlay J.M., Wallis M., Mantle A., Crawforth P., Ghadbeigi H. Destructive and non-destructive testing methods for characterization and detection of machining-induced white layer: a review paper. CIRP Journal of Manufacturing Science and Technology, 2018, vol. 23, pp. 39–53. DOI: 10.1016/j. cirpj.2018.10.001. Conflicts of Interest The authors declare no conflict of interest. ã 2025 The Authors. Published by Novosibirsk State Technical University. This is an open access article under the CC BY license (http:// creativecommons.org/licenses/by/4.0).
RkJQdWJsaXNoZXIy MTk0ODM1