OBRABOTKAMETALLOV technology Vol. 27 No. 1 2025 11. Świercz R., Oniszczuk-Świercz D., Chmielewski T. Multi-response optimization of electrical discharge machining using the desirability function. Micromachines, 2019, vol. 10 (72). DOI: 10.3390/mi10010072. 12. Świercz R., Oniszczuk-Świercz D. The effects of reduced graphene oxide flakes in the dielectric on electrical discharge machining. Nanomaterials, 2019, vol. 9 (3). DOI: 10.3390/nano9030335. 13. Chalisgaonkar R., Kumar J. Microstructural characteristics of pure titanium byWEDM. International Journal of Microstructure and Materials Properties, 2014, vol. 9 (6), pp. 463–484. DOI: 10.1504/IJMMP.2014.067308. 14. Mouralova K., Zahradnicek R., Benes L., Prokes T., Hrdy R., Fries J. Study of micro structural material changes after WEDM based on TEM lamella analysis. Metals, 2020, vol. 10 (7), p. 949. DOI: 10.3390/met10070949. 15. Mehmood S., Sultan A., Anjum N.A., Anwar W., Butt Z. Determination of residual stress distribution in high strength aluminum alloy after EDM. Advances in Science and Technology Research Journal, 2017, vol. 11 (1), pp. 29–35. DOI: 10.12913/22998624/68729. 16. Ablyaz T.R., Zhurin A.V., Shlykov E.S. Simulation of electrical discharge machining of dissimilar materials. ARPN Journal of Engineering and Applied Sciences, 2018, vol. 13 (6), pp. 2173–2177. 17. Kuo C.-G., Hsu C.-Y., Chen J.-H., Lee P.-W. Discharge current effect on machining characteristics and mechanical properties of aluminum alloy 6061 workpiece produced by electric discharging machining process. Advances in Mechanical Engineering, 2017, vol. 9 (11), pp. 1–8. DOI: 10.1177/1687814017730756. 18. Ghodsiyeh D., Golshan A.J., Shirvanehdeh A. Review on current research trends in wire electrical discharge machining (WEDM). Indian Journal of Science and Technology, 2013, vol. 6 (2), pp. 154–166. DOI: 10.17485/ ijst/2013/v6i2.18. 19. Muthuramalingam T., Saravanakumar D., Babu L.G., Nguen H.P., Vu N.P. Experimental investigation of white layer thickness on EDM processed silicon steel using ANFIS approach. Silicon, 2020, vol. 12, pp. 1905–1911. DOI: 10.1007/s12633-019-00287-2. 20. Wijaya H., Wahyudi S., Soenoko R., Setyarini P.H., Yasid S., Gapsari F. The effect of power supply current on recast layer in S45C steel using wire EDM. IOP Conference Series Materials Science and Engineering, 2019, vol. 494 (1). DOI: 10.1088/1757-899X/494/1/012102. Conflicts of Interest The authors declare no conflict of interest. 2025 The Authors. Published by Novosibirsk State Technical University. This is an open access article under the CC BY license (http://creativecommons.org/licenses/by/4.0).
RkJQdWJsaXNoZXIy MTk0ODM1