OBRABOTKAMETALLOV MATERIAL SCIENCE Том 23 № 3 2021 EQUIPMEN . INSTRUM TS Vol. 7 No. 2 2025 17. Ramírez-Gallego S., Krawczyk B., García S., Wozniak M., Herrera F. A survey on data preprocessing for data stream mining: current status and future directions. Neurocomputing, 2017, vol. 239, pp. 39–57. DOI: 10.1016/j. neucom.2017.01.078. 18. Wojciechowski S., Chwalczuk T., Twardowski P., Krolczyk G.M. Modeling of cutter displacements during ball end milling of inclined surfaces. Archives of Civil and Mechanical Engineering, 2015, vol. 15, pp. 798–805. DOI: 10.1016/j.acme.2015.06.008. 19. Kuscheva M.E., Klauch D.N., Kobelev O.A. Printsipy vybora smazochno-okhlazhdayushchikh tekhnologicheskikh sred dlya obrabotki metallov rezaniem [Principles of selection of cutting technological mediums for metal cutting]. Izvestiya MGTU MAMI, 2014, vol. 8, no. 1–2, pp. 73–76. DOI: 10.17816/2074-0530-67737. (In Russian). 20. Chehrehzad M., Kecibas G., Besirova C., Uresin U., Irican M., Lazoglu I. Tool wear prediction through AIassisted digital shadow using industrial edge device. Journal of Manufacturing Processes, 2024, vol. 113, pp. 117– 130. DOI: 10.1016/j.jmapro.2024.01.052. 21. Gimadeev M.R., Davydov V.M., Nikitenko A.V., Sarygin A.V. Formirovanie parametrov sherokhovatosti na osnove korrelyatsionnykh svyazei pri chistovom frezerovanii prostranstvenno-slozhnykh poverkhnostei [Formation of roughness parameters based on correlation relations during finishing milling of spatially complex surfaces]. Uprochnyayushchie tekhnologii i pokrytiya = Strengthening Technologies and Coatings, 2019, vol. 15, no. 6 (174), pp. 243–248. 22. GimadeevM.R., LiA.A.Analysis of automated surface roughness parameter support systems based on dynamic monitoring. Advanced Engineering Research (Rostov-on-Don), 2022, vol. 22 (2), pp. 116–129. DOI: 10.23947/26871653-2022-22-2-116-129. 23. Gimadeev M.R., Li A.A., Berkun V.O., Stelmakov V.A. Eksperimental’noe issledovanie dinamiki protsessa mekhanoobrabotki kontsevymi sferotsilindricheskimi frezami [Experimental study of the dynamics of the machining process by ball-end mills]. Obrabotka metallov (tekhnologiya, oborudovanie, instrumenty) = Metal Working and Material Science, 2023, vol. 25, no. 1, pp. 44–56. DOI: 10.17212/1994-6309-2023-25.1-44-56. Conflicts of Interest The authors declare no conflict of interest. 2025 The Authors. Published by Novosibirsk State Technical University. This is an open access article under the CC BY license (http://creativecommons.org/licenses/by/4.0).
RkJQdWJsaXNoZXIy MTk0ODM1