Obrabotka Metallov 2015 No. 4

ОБРАБОТКА МЕТАЛЛОВ № 4 (69) 2015 17 ТЕХНОЛОГИЯ of norming cut modes of a hard preparing materials by charactical lines and surfaces method used special experimental plans]. Nauchnyi vestnik NGTU – Science Bulletin of the Novosibirsk state technical university , 2011, no. 3 (44), pp. 149–158. 23. Zuperl U., Cus F. Optimization of cutting conditions during machining by using neural networks. Proceedings of the 12th International Conference on Flexible Automation and Intelligent Manufacturing , Dresden, Germany, 15–17 July 2002, pp. 502–511. 24. Dereli T., Filiz I.H., Baykasoglu A. Optimizing cutting parameters in process planning of prismatic parts by using genetic algorithms. International Journal of Production Research , 2001, vol. 39, iss. 15, pp. 3303–3328. doi: 10.1080/00207540110057891 25. Deepak S.S.K. Cutting speed and feed rate optimization for minimizing production time of turning process. International Journal of Modern Engineering Research , 2012, vol. 2, iss. 5, pp. 3398–3401. 26. Ab Rashid M.F.F., Izwandi S. Optimization of Turning Parameters to Minimize Production Cost using Genetic Algorithm. Proceedings of the 2nd CUTSE International Conference , Miri, Sarawak, Malaysia, November 24–25, 2009. Available at: http://umpir.ump.edu.my/5277/1/CUTSE_MOC_02_Optimization_of_Turning_Parameters_to_ Minimize_Production_Cost.PDF (accessed: 30.10.2015). 27. Kronenberg M. Machining science and application. Theory and practice for operation and development of machining processes. 1 st ed. Oxford, Pergamon Press, 1966. 410 p. Article history : Received 2 July 2015 Revised 3 August 2015 Accepted 20 October 2015