OBRABOTKAMETALLOV Vol. 28 No. 3 2026 359 MATERIAL SCIENCE 20. Zimogliadova T.A., Bataev A.A., Lazurenko D.V., Bataev I.A., Bataev V.A., Golkovskii M.G., Saage H., Ogneva T.S., Ruktuev A.A. Structural characterization of layers fabricated by non-vacuum electron beam cladding of Ni-Cr-Si-B self-fl uxing alloy with additions of niobium and boron. Materials Today Communications, 2022, vol. 33, p. 104363. DOI: 10.1016/j.mtcomm.2022.104363. 21. Ogneva T., Emurlaev K., Malyutina Y., Domarov E., Chakin I., RuktuevA., Riabinkina P., YurginA., Bataev I. Heat treatment induced structural transformations and high-temperature oxidation behavior of Al21Co22Cr22Fe13Ni22 high-entropy coatings produced by non-vacuum electron beam cladding. Metals, 2023, vol. 13 (10), p. 1689. DOI: 10.3390/met13101689. 22. Medvedeva N.I., Van Aken D.C., Medvedeva J.E. Stability of binary and ternary M23C6 carbides from fi rst principles. Computational Materials Science, 2015, vol. 96, pp. 159–164. DOI: 10.1016/j.commatsci.2014.09.016. 23. Fu H., Xiao Q., Kuang J., Jiang Z., Xing J. Eff ect of rare earth and titanium additions on the microstructures and properties of low carbon Fe–B cast steel. Materials Science and Engineering: A, 2007, vol. 466 (1–2), pp. 160– 165. DOI: 10.1016/j.msea.2007.02.032. 24. Macit C.K., Aksakal B., Horlu M. Enhancement on the tribological properties of 316L stainless steel via boron and alumina additions using mechanical alloying and powder metallurgy techniques. Ceramics International, 2025, vol. 51 (26), pp. 51549–51572. DOI: 10.1016/j.ceramint.2025.08.378. 25. Gao J., Ma J., Yang S., Guo Z., Ma J., Li H., Jiang Z., Han P. Grain boundary co-segregation of B and Ce hindering the precipitates of S31254 super austenitic stainless steel. Journal of Materials Research and Technology, 2023, vol. 24, pp. 2653–2667. DOI: 10.1016/j.jmrt.2023.03.135. 26. Berns H., Saltykova A., Röttger A., Heger D. Wear protection by Fe-B-C hard phases. Steel Research International, 2011, vol. 82 (7), pp. 786–794. DOI: 10.1002/srin.201000255. 27. Zhou Y., Chong X., Lin Y., Wang G., Jiang Y. Composition-dependent brittleness and ductility of the multicomponent phase (Fe, Cr)23(C, B)6 in Fe–Cr–B–C alloys: First-principles calculations and modeling. Vacuum, 2024, vol. 222, p. 113081. DOI: 10.1016/j.vacuum.2024.113081. 28. Li X., Wu P., Zhao S., Chen C., Yin R., Chen N. First-principle study of the solution type of boron in γ-iron. Energy Procedia, 2012, vol. 16, pp. 661–666. DOI: 10.1016/j.egypro.2012.01.107. 29. Zisman A.A., Soshina T.V., Khlusova E.I. Revealing prior austenite grains and analysis of the metadynamic recrystallization kinetics of austenite in hot rolled low carbon steel. Letters on Materials, 2012, vol. 2 (1), pp. 3–8. DOI: 10.22226/2410-3535-2012-1-3-8. 30. Razuvaev E.I., Kapitanenko D.V. Vliyanie termomekhanicheskoi obrabotki na strukturu i svoistva austenitnykh stalei [Eff ect of thermo-mechanical treatment on structure and properties of austenitic steels]. Trudy VIAM = Proceedings of VIAM, 2013, no. 5, p. 1–8. Confl icts of Interest The authors declare no confl ict of interest. © 2026 The Authors. Published by Novosibirsk State Technical University. This is an open access article under the CC BY license (http://creativecommons.org/licenses/by/4.0).
RkJQdWJsaXNoZXIy MTk0ODM1